ICT-Tool
The ICT-Tool can be used to configure the USB watchdog stick according to your needs. Define yourself how the two relay outputs should be switched before, during and after a timeout. This allows you to individually monitor your control PC.
Example:
This example uses the two relay outputs to show how the function of the watchdog stick could be configured.
This example uses the two relay outputs to show how the function of the watchdog stick could be configured.
| Condition | Relay 1 | Relay 2 |
| Deactivated (Monitoring not active) | OFF = Relay contacts open | ON = Relay contacts closed |
| Activated (Monitoring active) | OFF = Relay contacts open | OFF = Relay contacts open |
| Retriggered (Watchdog time is reset) | OFF = Relay contacts open | OFF = Relay contacts open |
| Timeout (watchdog time was not reset) |
ON = Relay contacts closed | ON = Relay contacts closed |
| Relais Setting after x msec (Time-delayed switching of the relays after a timeout) |
OFF = Relay contacts open | ON = Relay contacts closed |
Relay 1 switches on after a timeout and switches off again after time x has elapsed. This can be used as an external signal output, for example.
Relay 2 is connected to the reset switch of the PC to be monitored. After the timeout time has elapsed, it switches on for a certain time x and thus restarts the PC.
The timeout time and switch-on delay of the relays can be freely set.
- Configuration tool for the USB watchdog stick
- Intuitive operation
- Included free of charge with the USB watchdog stick