Configuration of our serial modules (RS-232 / RS-485)
To configure the serial interface, the module must be connected to the PC either via the Ethernet interface or USB interface.
The module can then be accessed and configured in the ICT tool.
The following parameters can be set:
- Preferred mode (115k baud, module address = deactivated, echo = off)
- Baud rate
- Module address (only for RS-485)
- Echo active on/off
- Text mode / Register mode
Changing the interface standard
Switch between RS-232 and RS-485 (applies only to NET and RO series)
The modules are configured for RS-232 operation as standard when delivered. The module can be switched to RS-485 operation by changing the jumper positions. Further information on this can be found in the manual for the respective product.
