The COS-DA4/8-16 module is available in versions with 4 or 8 analog outputs. It can be operated as a stand-alone device or in a network of several COS modules.
Due to the CANopen profiles according to the CiA® specification CiA 301, CiA 305 and CiA 401, this module is ideally suited for almost all applications in modern automation technology.
- CANopen profiles according to CiA® specification CiA 301, CiA 305 and CiA 401
- Galvanic isolation of the CAN bus
- Node number and baud rate configurable via coding switch or LSS
- 4 or 8 D/A channels each with 16-bit resolution
- Galvanic isolation: max. 1kV
- voltage ranges: 0-5V, 0-10V, +5V, +10V
- Current ranges: 0-20mA, 4-20mA, 0-24mA
- LED status indicators
Analogue outputs
With our digital to analog converter modules you are able to control current or voltage controlled actuators such as valves, servomotors or special power supplies. Especially in harsh industrial environments and with very long cable runs, analog signals, especially currents, can be transmitted interference-free.
Configuration
The baud rate (up to 1Mbit/s) and the node number of the module can be configured via coding switches. Alternatively, this configuration can also be carried out conveniently via LSS using a CANopen master in the bus.
The transmission can be optionally event-controlled, cyclic or synchronous. Thus, for example, digital input statuses can be sent to other BUS participants every second and additionally in the event of an input status change.
Dynamic PDO mapping also allows different types of measurement data to be sent in one PDO (e.g. analog and digital states).
Other nodes in the bus can be monitored via the heartbeat protocol. Each node cyclically sends a CAN message (heartbeat). If the message of a node is missing, e.g. due to a connection termination, this error is registered by the module and can switch an alarm, for example.
Easy installation thanks to DIN rail bus
Thanks to the practical COS bus connector, which is clipped into the top-hat rail, individual modules within a network can be very easily added or exchanged. CAN communication and the power supply is passed on to all connected modules via the DIN rail bus.
LEDs
At the front side of our COS modules there is a row of status LEDs. These give you a quick overview of the most important functions of the modules, such as the switching states of the individual I/Os, module status or whether clean communication via the DIN rail bus is possible. This can be very helpful for fast error analysis, especially for field applications.
Connectors
A screwless system from the manufacturer WAGO Kontakttechnik is used as the connector. The 1-wire female connectors are 100% protected against mismating and have an eject and locking mechanism. All conductor types up to 1.5mm² can be connected.
Reviews
There are no reviews yet.