More info

Ethernet-interface

Configuration over web interface

The ethernet module can be directly connected to a PC. That way, a direct access is given. It may be alternatively connected to a LAN. In case the LAN is accessible over the internet, the module is reachable worldwide. The configuration of the IP-address is done over the module's web interface, which is easily accessible by a browser. A provided API library in C allows an easily implement the module access in own programms.

Connector

Easy to maintain connector system

The plug and socket consist of a multipoint socket connector and a multipin connector with a throw-off lever. Plug-in and plug-out is easy as well as rewiring the terminal strip. The wire connection itself is realized with a screwless connector system. A tool is included with each module.

Config

Configuring the ethernet interface

Modules with 10/100 Mbit ethernet interface can be connected directly to a PC or to a network LAN. For configuration you can choose between two options.

1. Configuring using the DELIB Configuration Utility

Here you can change some basic options of the module.

2. Configuring by the internal Web-Browser

Here you can take advanced settings of the module.

Configuring by the DELIB Configuration Utility

DELIB Configuration Utility

DELIB Configuration Utility

Click to enlarge

If the default IP address of the module is not in the used network range, then the module can not be found over TCP/IP. Availability problems will also appear, if the IP address is already in use. But by using the DELIB Configuration Utility, the netmask and the IP address of the ethernet module can still be configured. Further, the module can directly be connected to the PC and be configured this way. After the accessibility is granted, further configuration is comfortably done by accessing the integrated web server.

Configuration using the module's integrated web-server

Web-Server

Web-Server

Click to enlarge

The internet module has it's own web-server via which the configuration may be done. Although the IP address and the netmask may be changed this way, much more can be configured than using the DELIB Configuration Utility.

Connector

Plug connection

Screwless plug connectors

All input and output connectors have a practical, screwless terminal block. An mechanic ejection guarantees a very quick module change without any special tools. Wire connection happens with screwdriver or an included plastic pin. (s. pic.1)

Pic1:

Connection example of a RO-Module

		RO-MODULE
		Step 1: Push the plastic tool into the small notch at the side of the terminal block, to open the clamp contacts for the wire connection.
		Step 2: When you are looking into the wire hole, you can see, that the clamp contacts have been opened. The end of the wire should be bared 5-7mm. Now put it as deep as possible into the opened hole.
		Step 3: After that, pull the plastic tool out of the notch. The clamp is closed again now.
		Step 4: After correct connecting, pull out the wiring by hand isn't no more possible

Downloads

Downloads

RO Flasher Update

RO Flasher Update
Flasher software for firmware update of the RO-CPU Modules and the Mini Sticks